プロが教える店舗&オフィスのセキュリティ対策術

デスクトップパソコンを作ろうとしています。

マザーボードの説明書には、CPU-FSB=400MHzのときにはPC2-3200を使うように書いてある(らしい)のですが、最近このメモリがあまり売っていません。

もし互換性のあるメモリがあれば、そちらのほうが多分安いので、そちらを使いたいのですが、どのメモリが互換性があるのでしょうか?

ちなみに性能は1GB×2=2GB。CPUはPentium4-1.6AGHzにしたいのです。
マザーボードはASRock P4i945GC。
よろしくお願い致します。

A 回答 (1件)

ん?そんな馬鹿な、と気になって説明書見て見ましたが、どこにも3200なんて文字は書いてありません(全検索)。


http://www.asrock.com/MB/manual.jp.asp?Model=P4i …
どなたがそういう意味不明なことをおっしゃったのかわかりませんが、最低の嘘言ってますねその方。

メモリは基本的に上位互換です。下記のどれでもけっこうです。安く売っているものを探して下さい。

DDR2-400=PC2-3200
DDR2-533=PC2-4200
DDR2-667=PC2-5300
DDR2-800=PC2-6400
DDR2-900=PC2-7200
DDR2-1000=PC2-8000
DDR2-1066=PC2-8500
DDR2-1150=PC2-9200
DDR2-1200=PC2-9600

下に行くほど高性能ですが、最高がDDR2-667みたいなのでそれが安ければ一番合理的ですね。無論より高性能なものがもっと安くてもそれでいいわけですが、せっかくの高性能が全く生かされていないw形になります。

検索したんで、コピペしておきましょう。

- Supports DDR2 667/533/400 non-ECC, un-buffered memory
(see CAUTION 4)
- Max. capacity of system memory: 4GB (see CAUTION 5)

CAUTION!
1. If you adopt FSB400-CPU on this motherboard, you need to adjust the
jumpers. Please refer to page 15 for proper jumper settings.
2. About the setting of “Hyper Threading Technology”, please check page 26.
3. This motherboard supports Untied Overclocking Technology. Please read
“Untied Overclocking Technology” on page 21 for details.
4. Please check the table below for the CPU FSB frequency and its corresponding memory support frequency.
CPU FSB Frequency Memory Support Frequency
800 DDR2 400, DDR2 533, DDR2 667
533 DDR2 400, DDR2 533
400 DDR2 400
5. Due to the chipset limitation, the actual memory size may be less than
4GB for the reservation for system usage under Windows®
XP and
Windows®
Vista
TM
.
6. The maximum shared memory size is defined by the chipset vendor and
is subject to change. Please check Intel®
website for the latest information.
7. For microphone input, this motherboard supports both stereo and mono
modes. For audio output, this motherboard supports 2-channel, 4-channel,
6-channel, and 8-channel modes. Please check the table on page 10 for
proper connection.
8. Before installing SATAII hard disk to SATAII connector, please read the “SATAII
Hard Disk Setup Guide” on page 20 to adjust your SATAII hard disk drive to
SATAII mode. You can also connect SATA hard disk to SATAII connector
directly.
9. Power Management for USB 2.0 works fine under Microsoft®
Windows®
Vista
TM
/ XP SP1 or SP2 / 2000 SP4.
10. ASRock Instant Flash is a BIOS flash utility embedded in Flash ROM.
This convenient BIOS update tool allows you to update system BIOS
without entering operating systems first like MS-DOS or Windows®
. With
this utility, you can press <F6> key during the POST or press <F2> key to
BIOS setup menu to access ASRock Instant Flash. Just launch this tool
and save the new BIOS file to your USB flash drive, floppy disk or hard
drive, then you can update your BIOS only in a few clicks without preparing an additional floppy diskette or other complicated flash utility. Please
be noted that the USB flash drive or hard drive must use FAT32/16/12 file
s y s t em.
11. Although this motherboard offers stepless control, it is not recommended
to perform over-clocking. Frequencies other than the recommended CPU
bus frequencies may cause the instability of the system or damage the
CPU.
12. While CPU overheat is detected, the system will automatically shutdown.
Before you resume the system, please check if the CPU fan on the
motherboard functions properly and unplug the power cord, then plug it
back again. To improve heat dissipation, remember to spray thermal
grease between the CPU and the heatsink when you install the PC system.
    • good
    • 0
この回答へのお礼

説明書まで調べていただき、大変助かりました。
ありがとうございます。

お礼日時:2012/01/19 18:15

お探しのQ&Aが見つからない時は、教えて!gooで質問しましょう!